Procedure For Commissioning The Et 200Mp Distributed I/O System; Commissioning The Et 200Mp For Profinet Io - Siemens SIMATIC S7-1500 System Manual

Commissioning

10.4 Procedure for commissioning the ET 200MP distributed I/O system

10.4 Procedure for commissioning the ET 200MP distributed I/O system
10.4.1

Commissioning the ET 200MP for PROFINET IO

Introduction
The commissioning of your automation system depends on the plant configuration.
The following procedure describes the commissioning of the distributed I/O system on an
IO controller.
Commissioning procedure
To commission the ET 200MP as an IO device for PROFINET IO, we recommend the
following procedure:
Table 10- 2
Step
1
2
4
5
6
7
8
9
10
Note
The operating mode transitions for the IO controller from RUN to STOP or from STOP to
RUN can take several milliseconds, until the mode transition for the inputs and outputs of all
I/O modules for the ET 200MP station is completed. This delay also applies to isochronous
mode.
150
Procedure for commissioning the ET 200MP as an IO device for PROFINET IO
Procedure
Install ET 200MP
Connect ET 200MP
Supply voltages
•
PROFINET IO
•
Sensors and actuators
•
Configure IO controller
Switch on supply voltages for IO controller
Switch on supply voltages for IO devices
Download configuration to the IO controller STEP 7 online help
Switch IO controller to RUN mode
Check LEDs
Test inputs and outputs
See...
Section Installation (Page 37)
Section Wiring (Page 51)
Documentation of the IO controller
Documentation of the IO controller
Interface module
(http://support.automation.siemens.com/WW/vie
w/en/67295970/133300) manual
Documentation of the IO controller
Interface module
(http://support.automation.siemens.com/WW/vie
w/en/67295970/133300) manual
The following functions are helpful: Monitoring
and modifying tags, testing with program status,
forcing, modifying the outputs. See section Test
functions and fault resolution (Page 198)
System Manual, 12/2014, A5E03461182-AC
Automation system