Siemens SIRIUS M200D Manual page 67

● Manual mode local
The motor starter can be controlled with:
– Integrated manual local control (key-operated switch + keypad, order variant)
– Local control station at digital inputs
The following message bits in diagnostics data set DS92 clearly indicate which control
source currently has control priority:
● Automatic mode
● Manual mode bus
● Manual mode bus, PC controls
● Manual mode local
● Input control
● HMI controls
● PC controls
● Connection abort in manual mode
Automatic Manual
Manual mode bus
Automatic Manual
mode mode bus
0 0
0 0
0 0
0 1
0 1
1 0
0 0
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
(Motor CW, Motor CCW, e.g. with switch module comprising test connector set or with
external switches)
Requirement: Manual mode local set (see below).
Note
A higher-priority mode can return control priority to a lower-priority mode by command
or the input action "Manual mode". This can take place using the command "Automatic
mode" or by switching off the input action "Manual mode local".
Manual mode local
Manual Manual Input
mode bus, mode control
PC controls local
0 1 0
0 1 0
0 1 1
1 0 0
0 0 0
0 0 0
0 1 0
3.10 Communication over PROFIBUS/PROFINET
Connection
abort in
HMI PC
manual mode
controls controls
0 1 0
0 0 1
0 0 0
0 0 0
0 0 1
0 0 0
1 0 0
Functions
Control priority
PC via device interface
or operator panel
None
Digital input
PC via fieldbus
None
Controller (PLC)
HMI device
67