Requirements - Siemens SIRIUS M200D Manual

Commissioning

6.2 Requirements

6.2 Requirements
Software requirements
Configuration software used
Configuring software for the
master/controller used
Configuring software
Motor Starter ES
(optional accessories)
Commissioning requirements
Prior activity
1.
2.
3.
4.
5.
6.
7.
8.
136
Motor starter and communication module
mounted and connected
PROFIBUS address set on the motor starter (on
PROFIBUS only)
Supply voltage for motor starter switched on
Supply voltage for load switched on (if
necessary)
Motor starter configured (configured and
parameterized)
Assign device name for motor starter
(on PROFINET only)
Supply voltage for master/controller switched on
Master/controller is switched to RUN mode
Explanations
See the manual of the master/controller
Order No.: 3ZS1310-6CC10-0YA5
For parameterizing, operating and monitoring using a local
device interface or fieldbus interface
(See online help of Motor Starter ES)
For more information, see ...
Chapter Mounting/connection
Chapter Mounting (Page 100)
Motor manual
Chapter Configuration/parameterization
(Page 119)
Chapter Configuration (Page 123)
Manual for master/controller
Manual for master/controller
Manual, 08/2014, A5E01577426A/RS-AA/004
M200D PROFIBUS/PROFINET