Commands - Siemens SIRIUS M200D Manual

Functions
3.10 Communication over PROFIBUS/PROFINET
Connection monitoring
If the motor starter is controlled via the device interface (Motor Starter ES or hand-held
device), this connection is monitored. If this connection is broken, the motor shuts down with
the message "Connection abort in manual mode".
To exit this state, re-establish the connection and control again using the device interface.
Setting manual mode local for local control station at the digital inputs
You can set manual mode local as follows:
● Parameterize the input n action "Motor CW" or "Motor CCW" and the input n action of
another input as "Manual mode local".
● As long as the second input is active, the motor starter remains in "manual mode local"
and the motor can be controlled via the digital input "Motor CW" / "Motor CCW".
3.10.2

Commands

Commands and their meaning
Using the commands, you can instruct the motor starter to perform specific actions. You can
send the following commands to the motor starter with the Motor Starter ES configuring
software, for example:
Command
Trip reset
Emergency start ON
Emergency start OFF
Automatic mode
Manual mode
Factory settings
Delete maximum pointer
Restart
68
Meaning
Resets and acknowledges error messages
•
Deletes message bits, if no error message is present
•
No effect
•
Activates the emergency start device function
Deactivates the emergency start device function
Control via PLC;
cyclic and acyclic bus channel (C1)
Control via PC; acyclic bus channel (C2)
•
Control via the device interface
•
All parameters assume the factory settings again except the
communication parameters. Only possible in manual mode!
Deletes the "preventive diagnostics" statistical data
Motor starter executes restart (same effect as Power
OFF/ON). Only possible in manual mode!
Manual, 08/2014, A5E01577426A/RS-AA/004
M200D PROFIBUS/PROFINET