Removing The Sprayer And Tank Skid - Toro Multi Pro WM Operator's Manual

B. Grease the sprayer; refer to
(page 70).
C. Check and tighten all bolts, nuts, and
screws.
Note:
Repair or replace any parts that
are worn or damaged.
D. Check the condition of all spray hoses.
Note:
Replace any hoses that are worn
or damaged.
E. Tighten all hose fittings.
F. Paint all scratched or bare metal
surfaces with paint is available from your
Authorized Service Dealer.
G. Store the machine in a clean, dry garage
or storage area.
H. Remove the key from the starter switch
and put the key in a safe place out of the
reach of children.
I. Cover the machine to protect it and keep
it clean.
Removing the Sprayer and
Tank Skid
Lifting equipment capacity: 408 kg (900 lb)
DANGER
The sprayer tank assembly presents a stored
energy hazard. If not properly retained when
installing or removing the assembly it can
move or fall and injure you or bystanders.
Use straps and an overhead lift to support
the sprayer tank assembly during installation,
removal, or any maintenance whenever you
remove the retaining fasteners.
Preparing the Center Console
1. Disconnect the battery cables from the battery;
refer to 6 Disconnecting the Battery (page
2. Separate the fuse block of the sprayer from the
fuse block of the machine and disconnect the
wiring between the 2 fuse blocks; refer to
Installing the Sprayer Fuse Block (page
3. Remove the wire harness from J-clips; refer
to Routing the Rear Electrical Harness for the
Sprayer to the Control Console (page
4. Loosen the hand knob that is located below
the console and remove the hairpin; refer to
Lubrication Installing the Control Console to the Machine
(page
5. Disconnect the terminals of the wires that
connect the fuse block for the sprayer with the
fuse block of the machine; refer to
the Sprayer Fuse Block (page
6. Separate the fuse block for the sprayer from the
fuse block for the machine; refer to
the Sprayer Fuse Block (page
7. Remove the console from the console-mounting
bracket at the dash of the machine and align the
pivot pin on the control console with the storage
bracket at the front tank strap
to
(page
1. Control console
2. Storage bracket (front
sprayer-tank strap)
8. Assemble the console to the bracket and secure
the pivot pin to the bracket with the hairpin
(Figure
21).
11
25).
24).
87
24).
Installing the Control Console to the Machine
24).
Figure 129
3. Hairpin
129).
11 Installing
25).
11 Installing
25).
(Figure 129); refer
g033615