Installing The Tank Skid - Toro 41235 Operator's Manual

9

Installing the Tank Skid

Parts needed for this procedure:
1 Tank and skid assembly
2 Clevis pins
4 Lynch pins
2 Bolt (1/2 x 1-1/2 inches)
4 Washers (1/2 inch)
2 Nuts (1/2 inch)
Procedure
DANGER
The sprayer tank assembly represents a stored
energy hazard. If not properly retained when
installing or removing the assembly it can move or
fall and injure you or other bystanders.
Use straps and an overhead lift to support the
sprayer tank assembly during installation, removal
or any maintenance when the retaining fasteners
are being removed.
1. Using a lift, raise the tank skid assembly and position
over the vehicle frame with the pump and valve
assemblies facing rearward.
Note: The following steps are recommended to be
performed with the help of another person.
2. Slowly lower the tank skid to the frame.
3. Reconnect the negative battery cable and start the
vehicle to energize the hydraulic pumps.
4. Extend the lift cylinders to the brackets on the tank
skid. Align the cylinder arms with the holes in the tank
skid brackets (Figure 20).
2
1
G011759
1. Support straps
2. Lift cylinders
3. Tank skid brackets
5. Use the clevis pin and lynch pin to secure the tank skid
to the lift cylinders on both sides of the vehicle.
6. Line up the pivot lug at the rear of the tank skid
assembly with the opening at the end of the vehicle
frame (Figure 21).
1. Pivot lug
2. Clevis pin (3/4 inch)
7. Install a clevis pin (3/4 inch) and two lynch pins to
the pivot lug to secure the tank assembly to frame
(Figure 21).
8. Extend the lift cylinders to raise the tank and support
its weight. Disconnect the tank assembly from its
overhead support at this time.
9. Use lift cylinders lower the tank to the frame.
19
3
4
Figure 20
4. Clevis pin
5. Lynch pin
Figure 21
Left side shown
3. Lynch pin
4. Vehicle frame
5