Safety; General Safety; Safe Operating Practices; Training - Toro Multi Pro WM Operator's Manual

Safety

Important:
Read and understand the information
in the safety section of the Operator's Manual
for your Workman vehicle before operating the
machine.

General Safety

This product is capable of causing personal injury.
Always follow all safety instructions to avoid serious
personal injury.
•
Read and understand the contents of this
Operator's Manual before starting the engine.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Use appropriate personal protective equipment
(PPE) to guard against contact with chemicals.
Chemical substances used in the sprayer system
may be hazardous and toxic.
•
Do not put your hands or feet near moving
components of the machine.
•
Do not operate the machine without all guards
and other safety protective devices in place and
working on the machine.
•
Keep clear of any discharge area of the sprayer
nozzles and spray drift. Keep bystanders and
children out of the operating area.
•
Never allow children to operate the machine.
•
Shut off the engine, remove the key (if equipped),
and wait for all movement to stop before you leave
the operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
Improperly using or maintaining this machine can
result in injury. To reduce the potential for injury,
comply with these safety instructions and always
pay attention to the safety-alert symbol
means Caution, Warning, or Danger—personal safety
instruction. Failure to comply with these instructions
may result in personal injury or death.
Not all the attachments that adapt to this machine
are covered in this manual. Refer to the operator's
manual provided with each attachment for additional
safety instructions.

Safe Operating Practices

Important:
The machine is designed primarily
as an off-road vehicle and is not intended for
extensive use on public roads.
When using the machine on public roads, follow
all traffic regulations and use any additional
accessories that may be required by law, such as
lights, turn signals, slow-moving vehicle (SMV)
sign, and others as required.
The Workman was designed and tested to offer
safe service when operated and maintained
properly. Although hazard control and accident
prevention depend upon the design and
configuration of the machine, these factors
also depend on the awareness, concern, and
proper training of the personnel involved in
the operation, maintenance, and storage of the
machine. Improperly using or maintaining the
machine can result in injury or death.
The Workman is a specialized utility vehicle designed
for off-road use only. The ride and handling of the
machine has a different feel than that of passenger
cars or trucks. Take time to become familiar with your
machine.
Not all the attachments that adapt to the Workman
are covered in this manual. See the Installation
Instructions provided with attachment for additional
safety instructions.
To reduce the potential for injury or death, comply with
the following safety instructions:
Supervisor's Responsibilities
•
Make sure that operators are thoroughly trained
and familiar with the Operator's Manual, the
Operator's Manual of the Workman machine,
training material, engine manual, and all labels on
the Workman machine.
•
Establish your own special procedures and work
rules for unusual operating conditions (e.g., slopes
too steep for machine operation). Use the third
high lockout switch if high speed could result in a
safety or machine abuse situation.
, which

Training

•
Read the Operator's Manual and other training
material before operating the machine.
Note:
read the manual language, it is the owner's
responsibility to explain this material to them.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
All operators and mechanics should be trained.
The owner is responsible for training the users.
•
Never allow untrained people to operate or service
the equipment.
4
If the operator(s) or mechanic(s) cannot