Cleaning The Sprayer Valves - Toro Multi Pro WM Operator's Manual

Cleaning the Sprayer
Valves
•
To clean the rate control valve, refer to the
following sections:
1. Removing the Valve Actuator (page 76)
2. Removing the Rate Control Manifold Valve
(page 77)
3. Cleaning the Manifold Valve (page 81)
4. Assembling the Manifold Valve (page 82)
5. Installing the Rate Control Manifold Valve
(page 83)
6. Installing the Valve Actuator (page 86)
•
To clean the agitation valve; refer to the following
sections:
1. Removing the Valve Actuator (page 76)
2. Removing the Agitation Manifold Valve
(page 78)
3. Cleaning the Manifold Valve (page 81)
4. Assembling the Manifold Valve (page 82)
5. Installing the Agitation Manifold Valve (page
83)
6. Installing the Valve Actuator (page 86)
•
To clean the master-boom valve, refer to the
following sections:
1. Removing the Valve Actuator (page 76)
2. Removing the Master Boom Manifold Valve
(page 79)
3. Cleaning the Manifold Valve (page 81)
4. Assembling the Manifold Valve (page 82)
5. Installing the Master Boom Manifold Valve
(page 84)
6. Installing the Valve Actuator (page 86)
•
To clean the 3 section valves; refer to the following
sections:
1. Removing the Valve Actuator (page 76)
2. Removing the Section Manifold Valve (page
80)
3. Cleaning the Manifold Valve (page 81)
4. Assembling the Manifold Valve (page 82)
5. Installing the Section Manifold Valve (page
85)
6. Installing the Valve Actuator (page 86)
Removing the Valve Actuator
1. Park the machine on a level surface, engage the
parking brake, shut off the pump, shut off the
engine, and remove the key.
2. Remove the 3-pin connector of the valve
actuator from the 3 socket electrical connector
of the sprayer harness.
3. Remove the retainer that secures the a actuator
to the manifold valve for the rate control
valve, agitation valve, master-boom valve, or
boom-section valve
Note:
Squeeze the 2 legs of the retainer
together while pushing it down.
Note:
Retain the actuator and retainer for
installation in Installing the Valve Actuator (page
86).
Section valve actuator shown (the agitation-valve actuator
1. Valve actuator (section
valve shown)
2. Retainer
4. Remove the actuator from the manifold valve.
76
(Figure 109).
Figure 109
is similar)
3. Stem port
g028237