Installing The Radiator Cover; Installing The Tank Skid; Radiator Cover; Bolts, 3/8 X 1 Inch - Toro 41229 Operator's Manual

3. Repeat steps to install the hold-down bracket on the
opposite side.

Installing the Radiator Cover

1. Locate the spray system power connector on the
wiring harness installed previously.
2. Install the radiator cover assembly over the vehicle's
radiator (Fig 15).
Important Make sure the spray system power
connecter is routed toward the front of the vehicle and not
trapped under the radiator cover assembly.
3. Secure the cover to the frame using four bolts
(3/8 x 1 inch).
1
2
Figure 15
Left hand side shown
1. Radiator cover assembly
2. Bolt, 3/8 x 1 inch
Installing the Radiator Panel on Air
Cooled Vehicles
An additional panel is attached to the front, left of the
radiator cover assembly on all vehicles with air cooled
engines.
4. Install the radiator panel to the radiator cover assembly
by lining the three drilled holes in the panel with the
corresponding holes in the cover assembly.
Important Make sure the spray system power
connecter is routed toward the front of the vehicle and not
trapped under the radiator cover assembly.
5. Secure the panel to the cover using three bolts
(1/4 x 3/4 inch).
3
3. Spray system power
connector
18

Installing the Tank Skid

1. Using a lift, raise the tank skid assembly and position
over the vehicle frame with the pump and valve
assemblies facing rearward.
2. Turn the prop rod 90° and guide it through the prop
rod support (Fig 16) as the tank skid is slowly lowered.
3
Figure 16
1. Tank skid assembly
2. Prop rod, turned 90°
3. Once the prop rod is through the support assembly,
turn the prop rod 90° to retain it within the support and
continue to lower the tank skid assembly to the vehicle
frame.
4. Use the access panels on both sides of the tank skid to
check for pinching of any hoses or wiring (Fig 17).
Figure 17
Right side shown
1. Access panel door
1
2
3. Prop rod support
assembly
2
1
2. Interior of the tank skid