Toro Multi Pro WM Operator's Manual page 78

Removing the Agitation Manifold
Valve
1. Remove 3 flange clamps and 3 gaskets that
secure the manifold for the agitation valve
(Figure 112) to the agitation bypass valve, rate
control valve, and master-boom valve.
Note:
Retain the flange clamps and gaskets for
installation in Installing the Agitation Manifold
Valve (page 83).
Figure 112
1. Flange (pressure filter
head)
2. Manifold (agitation valve)
3. Flange (bypass
valve—agitation valve)
4. Flange clamp
2. Remove the retainer that secure the
quick-disconnect socket to the manifold
quick-disconnect coupling for the agitation valve
(Figure 113).
g033586
5. Gasket
6. 3-pin connector (valve
actuator—agitation valve)
7. Flange (master-boom
valve)
1. Flange-head bolt (1/4 x
3/4 inch)
2. Manifold valve (agitation
valve)
3. Valve mount
4. Flange locknut (1/4 inch)
3. Remove the flange-head bolt (1/4 x 3/4 inch) and
flange locknut (1/4 inch) that secure the agitation
valve to the valve mount and remove the valve
manifold from the machine
Note:
Retain the flange head bolt, flange
locknut, and retainer for installation in
the Agitation Manifold Valve (page
78
Figure 113
5. Retainer
6. Quick-disconnect fitting
(socket)
7. Quick-disconnect fitting
(coupling)
(Figure 113).
Installing
83).
g214596