Adjusting The Booms To Level - Toro Multi Pro WM Operator's Manual

Note:
The following machine components are
considered parts subject to consumption through use
unless found defective and are not covered by the
Warranty associated with this machine.
Have an Authorized Toro Service Distributor check the
following internal pump components for damage:
•
Pump diaphragm
•
Pump check valve assemblies
Replace any components if necessary.
Adjusting the Booms to
Level
The following procedure can be used to adjust the
actuators on the center boom to keep the left and
right booms at level.
1. Extend the booms to the spray position.
2. Remove the cotter pin from the pivot pin
105).
Figure 105
1. Actuator
2. Actuator rod
3. Boom-pivot pin housing
3. Lift up on the boom and remove the pin
105), and slowly lower the boom to the ground.
4. Inspect the pin for any damage, and replace it
if necessary.
5. Use a wrench on the flat sides of the actuator
rod to immobilize it, then loosen the jam nut to
allow the eyelet rod to be adjusted
(Figure
g013780
4. Cotter
5. Pin
(Figure
(Figure 106).
1. Flat on the actuator rod
2. Jam nut
3. Eyelet
4. Jam nut loosened
6. Turn the eyelet rod in the actuator rod to shorten
or lengthen the extended actuator to the desired
position (Figure
Note:
You must turn the eyelet rod in half or
complete revolutions so that you can assemble
the rod to the boom.
7. Once the desired position has been achieved,
tighten the jam nut to secure the actuator and
eyelet rod.
8. Raise the boom to align the pivot with the
actuator rod.
9. While holding the boom, insert the pin through
both boom pivot and actuator rod
10. With the pin in place, release the boom and
secure the pin with the cotter previously
removed.
11. Repeat the procedure for each actuator rod
bearing, if necessary.
74
Figure 106
5. Eyelet adjusted
6. Eyelet position for
assembly
7. Jam nut tightened to lock
new position
106).
(Figure
g014220
105).