Spray Filter Recommendations - Toro Multi Pro WM Operator's Manual

agitation nozzles in the tank when the master boom
switch is set to the O
FF
1. Ensure that the sprayer tank is filled with water.
2. Engage the parking brake.
3. Set the transmission as follows:
•
For HD-Series Models with a manual
transmission—shift the transmission to the
N position.
EUTRAL
•
For the HDX-Auto model—shift the
transmission to P (park).
4. Turn on the sprayer pump.
5. Set the agitation switch to the O
6. Set the master boom switch to the O
7. Set the engine speed as follows:
•
For machines without the optional throttle
lock—have 1 person press down on the
accelerator pedal until the engine reaches
maximum speed.
Note:
Have the other person collect
samples from the sprayer nozzles.
•
For machines with the optional throttle lock,
press down on the accelerator pedal until the
engine reaches maximum speed and set the
throttle lock; refer to operation instructions
for your Workman hand throttle kit.
8. Adjust the master-boom bypass handle to
control the amount of agitation occurring in the
tank (Figure 89).
9. Reduce the throttle speed to idle.
10. Set the agitation switch and pump switch to the
O position.
FF
11. Shut off the engine.
Spray Filter
Recommendations
Selecting a Suction Filter
Standard Equipment: 50 mesh suction filter (blue)
Use the suction filter table to identify the screen
mesh for the spray nozzles you are using based
on chemicals products or solutions with a viscosity
equivalent to water.
Suction Filter Table
Spray Nozzle Screen Mesh
Color Code (flow Size*
rate)
Yellow (0.2 gpm) 50
Red (0.4 gpm) 50
position.
position.
N
position.
FF
Filter Color Code
Blue
Blue
Suction Filter Table (cont'd.)
Spray Nozzle Screen Mesh
Color Code (flow Size*
rate)
Brown (0.5 gpm) 50 (or 30)
Gray (0.6 gpm) 30
White (0.8 gpm) 30
Blue (1.0 gpm) 30
Green (1.5 gpm) 30
*The mesh size of the suction filters in this table
are based on spray chemicals or solutions with the
viscosity equivalent to water.
Important:
When you spray with higher viscosity
(thicker) chemical products or solutions with
wettable powders, you may need to use an coarser
screen mesh for the optional suction filter; refer
to Figure 90.
Mesh size—chemical or solution viscosity
1. Higher-viscosity chemicals
or solutions
2. Lower-viscosity chemicals
or solutions
When you spray at a higher application rate, consider
using an courser optional suction-filter mesh; refer
to Figure 91.
64
Filter Color Code
Blue (or green)
Green
Green
Green
Green
Figure 90
3. Screen mesh size
g214212