Toro Multi Pro WM Operator's Manual page 42

Master-Boom Switch
The master-boom switch allows you to start or stop
the all spray operation. Press the switch to run or stop
the spray system (Figure
Boom-Section Switches
The boom-section switches are located along the
bottom of the control panel
each switch upward to turn the sprayers for the
corresponding boom section on and downward to turn
the sprayers off. When the boom-section switch is set
to the O position, the light on the switch illuminates.
N
These switches only affect the spray system when the
master-boom switch is in the O
Application-Rate Switch
The application-rate switch is located on the left
side of the control panel
hold the switch upward to increase the spray system
application rate, or press and hold it downward to
decrease application rate.
Boom-Lift Switches
The electric boom-lift switches raise and lower their
respective booms (Figure
lift switch. Press and hold the switch upward to raise
the respective boom, or press and hold the switch
downward to lower the respective boom.
Sprayer-Mode Switch (HDX-Auto
Model)
Use the sprayer-mode switch to select between the
following spraying methods:
•
Use the manual mode when you want to manually
control the sprayer application rate.
•
Use the automatic mode when you want the
computer to control sprayer application rate with
setting you enter in the InfoCenter.
52).
(Figure 52). Toggle
position.
N
(Figure 52). Press and
52). There is a left and right
1. InfoCenter console
2. Sprayer-mode switch
Regulating (Rate Control) Valve
The regulating valve located behind the tank
54), The regulating valve controls the amount of fluid
that is routed to the booms or the rate return to the
tank.
1. Regulating (rate control)
valve
2. Agitation valve
3. Master-boom valve
42
Figure 53
3. Automatic mode
(sprayer-mode switch
position)
4. Manual mode
(sprayer-mode switch
position)
Figure 54
4. Flow meter
5. Boom section valves
g028486
(Figure
g028483