Assembling The Sprayer Tank Fill Fitting - Toro Multi Pro 5800-D Operator's Manual

B. Use the jam nut to compress any spring
that measures greater than 3.96 cm (1.56
inches).
1. Boom-hinge spring
4. Repeat the procedure for each spring on both
boom hinges.
5. Move the booms into the transport "X" position;
refer to Operating the Boom-Transport Cradle
(page 32).
2
Assembling the Sprayer
Tank Fill Fitting
Parts needed for this procedure:
1 Quick-disconnect fitting
Procedure
Note:
To complete this procedure, you will need to
supply a hose with 1 inch male national pipe thread
(NPT) fitting and PTFE thread sealant.
1. At the forward, right side of the tank cover,
remove the 2 hairpins that secure the latches for
the quick-disconnect coupling for the anti-siphon
fill receptacle (Figure
Figure 3
2. Jam nut
4).
1. Quick-disconnect fitting
g002332
2. Hairpins
2. Rotate the latches open to unlock
the quick-disconnect fitting from the
quick-disconnect coupling
3. Remove the quick-disconnect fitting from the
quick-disconnect coupling
4. Close the latches and install the hair pins into
the flanges of the quick-disconnect coupling
(Figure 4).
5. Apply PTFE thread sealant
threads of the fill hose fitting (1 inch—national
pipe thread).
1. PTFE thread sealant
2. fill hose fitting (1
inch—national pipe
thread)
6. Thread the quick-disconnect coupling onto the
fill hose and tighten it by hand
16
Figure 4
3. Latches (quick-disconnect
coupling)
(Figure 4).
(Figure 4).
(Figure 5) to the
Figure 5
3. Quick-disconnect fitting
(Figure 5).
g191617
g191615