Toro Multi Pro WM Operator's Manual page 43

Flow meter
The flow meter measures the flow rate of the fluid to
the boom section valves
Boom-Section Valves
Use the boom-section valves to turn the sprayer
pressure on or off to the sprayer nozzles in the left,
center, and right boom sections
Boom Section-Bypass Valves
The boom section-bypass valves
the fluid flow from a boom to the tank when you turn
off the boom section. You can adjust these valves to
ensure that the boom pressure remains constant no
matter which combination of booms you are operating;
refer to Calibrating the Boom Bypass (page
Figure 55
1. Left boom section-bypass
valve
2. Center boom
section-bypass valve
Agitation-Throttle Valve
This valve is located on the rear left side of the tank
(Figure 56). Turn the knob on the valve to the 6
o'clock position to turn on the tank agitation and to the
8 o'clock position to turn off the tank agitation.
(Figure 54).
(Figure 54).
(Figure 55) redirect
62).
3. Right boom
section-bypass valve
1. Agitation-control valve
Note:
HD-series models with a manual
transmission—for agitation to work the PTO and
clutch must be engaged and the engine must be
running above an idle. If you stop the sprayer and
need agitation circulating the content of the tank,
place the range shift lever in the N
out the clutch, engage the parking brake, and set the
hand throttle (if equipped).
Sprayer Pump
The sprayer pump is located at the rear of the machine
(Figure 57).
Control the sprayer pump by performing the following:
g028485
•
For the HD-series model with a manual
transmission—At the center console of the
machine, move the PTO lever to the
position to run the pump; move the PTO lever to
the
DISENGAGE
the Workman HDX-Auto Utility Vehicle Operator's
Manual.
•
For the HDX-Auto model—At the dash panel to
the left of the steering-wheel column, press the
rocker switch for the high-flow hydraulic system up
to the O position to run the sprayer pump (the
N
light of the rocker switch illuminates). Press the
rocker switch down to the O
sprayer pump. Refer to the High-Flow Hydraulic
Kit Installation Instructions (the light of the rocker
switch shuts off).
43
Figure 56
EUTRAL
position to stop the pump. Refer to
position shut off the
FF
g033579
position, let
ENGAGE