Installing The Tank Skid; Tank And Skid Assembly; Clevis Pins; Tapered Clevis Pin - Toro Multi Pro WM 41240 Operator's Manual

6

Installing the Tank Skid

Parts needed for this procedure:
1

Tank and skid assembly

2

Clevis pins

2

Tapered clevis pin

2

Hair pins

4

Lynch pins

2

Bolt (1/2 x 1-1/2 inches)

2

Nuts (1/2 inch)

Procedure
DANGER
The sprayer tank assembly represents a stored
energy hazard. If not properly retained when
installing or removing the assembly, it can move or
fall and injure you or other bystanders.
Use straps and an overhead lift to support the
sprayer tank assembly during installation, removal,
or any maintenance when the retaining fasteners
are being removed.
1. Using a lift, raise the tank skid assembly (Figure 9) and
position it over the vehicle frame with the pump and
valve assemblies facing rearward.
Note: Have another person help you perform the
following steps.
1. Rear lift point
Figure 9
2. Front lift point
2. Slowly lower the tank skid to the frame.
3. Connect the negative battery cable and start the vehicle
to energize the hydraulic pumps.
4. Extend the lift cylinders to the brackets on the tank
skid, and align the cylinder arms with the holes in the
tank skid brackets (Figure 10).
1. Hair pin
2. Clevis pin
5. Use the clevis pin and hair pin to secure the tank skid
to the lift cylinders on both sides of the vehicle.
6. Line up the pivot lug at the rear of the tank skid
assembly with the opening at the end of the vehicle
frame (Figure 11).
1. Tapered clevis pin
7. Install a tapered clevis pin and 2 lynch pins to the pivot
lug to secure the tank assembly to the frame (Figure 11).
8. Extend the lift cylinders to raise the tank and support
its weight.
Note: Disconnect the tank assembly from its overhead
support.
9. Connect the existing speed sensor to the speed-sensor
plug and the speed-sensor-output plug on the new
wiring harness (Figure 12).
15
G022353
Figure 10
3. Lift cylinders
2
1
G022354
Figure 11
2. Lynch pin
1
2
3