Assembling The Sprayer Tank Fill Fitting - Toro Multi Pro 5800-G Operator's Manual

B. Use the jam nut to compress any spring
that measures greater than 3.96 cm (1.56
inches).
1. Boom-hinge spring
4. Repeat the procedure for each spring on both
boom hinges.
5. Move the boom sections into the transport "X"
position; refer to
Cradle (page 31).
2
Assembling the Sprayer
Tank Fill Fitting
Parts needed for this procedure:
1 Quick-disconnect fitting
Procedure
Note:
To complete this procedure, you will need to
supply a hose with 1 inch male national pipe thread
(NPT) fitting and PTFE thread sealant.
1. At the forward, right side of the tank cover,
remove the 2 hairpins that secure the latches for
the quick-disconnect coupling for the anti-siphon
fill receptacle (Figure
Figure 3
2. Jam nut
Operating the Boom-Transport
4).
1. Quick-disconnect fitting
g002332
2. Hairpins
2. Rotate the latches open to unlock
the quick-disconnect fitting from the
quick-disconnect coupling
3. Remove the quick-disconnect fitting from the
quick-disconnect coupling
4. Close the latches and install the hair pins into
the flanges of the quick-disconnect coupling
(Figure 4).
5. Apply PTFE thread sealant
threads of the fill hose fitting (1 inch—national
pipe thread).
1. PTFE thread sealant
2. Fill-hose fitting (1
inch—national pipe
thread)
6. Thread the quick-disconnect coupling onto the
fill hose and tighten it by hand
16
Figure 4
3. Latches (quick-disconnect
coupling)
(Figure 4).
(Figure 4).
(Figure 5) to the
Figure 5
3. Quick-disconnect fitting
(Figure 5).
g191617
g191615