Toro Multi Pro WM Operator's Manual page 77

Removing the Rate Control
Manifold Valve
1. Remove 2 flange clamps and 2 gaskets that
secure the manifold for the rate control valve
(Figure 110) to the pressure filter and agitation
valve.
Note:
Retain the flange clamps and gaskets
for installation in
Manifold Valve (page
Figure 110
1. Flange (pressure filter
head)
2. Manifold (rate control
valve)
3. Flange (agitation valve)
2. Remove the retainer that secure the outlet fitting
to the manifold coupling for the rate control valve
(Figure 111).
Installing the Rate Control
83).
4. Flange clamp
5. Gasket
6. 3-pin connector (valve
actuator—rate control
valve)
1. Flange-head bolt (1/4 x
3/4 inch)
2. Valve mount
3. Flange locknut (1/4 inch)
3. Remove the 2 flange-head bolts (1/4 x 3/4 inch)
and 2 flange locknuts (1/4 inch) that secure
g033584
the rate control valve to the valve mount and
remove the valve manifold from the machine
(Figure 111).
Note:
If necessary, loosen the mounting
hardware for the pressure filter head to ease
removal of the rate control valve.
Note:
Retain the flange-head bolts, flange
locknuts, and retainer for installation in
the Rate Control Manifold Valve (page
77
Figure 111
4. Retainer
5. Socket (outlet fitting)
6. Coupling (manifold—rate
control valve)
g033585
Installing
83).