Toro Multi Pro WM Operator's Manual page 85

Figure 127
1. Manifold (master-boom
valve)
2. Valve mount
3. Flanged locknut (1/4 inch)
6. Secure the outlet fitting coupling fitting by
inserting a retainer into the socket of the outlet
fitting (Figure 127).
7. Assemble the agitation valve to the valve mount
with the flanged-head bolt and flanged locknut
(Figure 126) that you removed in step
Removing the Master Boom Manifold Valve
(page 79) and torque the nut and bolt to 10 to 12
N∙m (90 to 110 in-lb).
g033591
4. Flanged-head bolt (1/4 x
3/4 inch)
5. Retainer
6. Socket (90° outlet fitting)
3 of
Installing the Section Manifold
Valve
1. Insert the upper end-cap fitting of the manifold
valve into the bypass fitting
Note:
If needed, loosen the mounting hardware
for the bypass fitting to provide clearance.
1. Flange (reducer coupling)
2. Socket (bypass fitting)
3. Bypass fitting
4. Flange (adjacent
manifold—agitation valve)
5. End-cap fitting (manifold
valve assembly)
2. Secure the end-cap fitting to the bypass fitting
by inserting a retainer into the socket of the
bypass fitting
3. Assemble the outlet fitting onto the lower
end-cap fitting of the manifold valve
128A).
4. Secure the end-cap fitting to the outlet fitting by
inserting a retainer into the socket of the outlet
fitting (Figure
5. Align a gasket between the flanges of the
reducer coupling and the section valve manifold
(Figure 128B).
6. Assemble the reducer coupling, gasket, and
section valve manifold with a clamp and tighten
by hand (Figure
7. If installing the 2 left most section valves, align
a gasket between the flanges of the 2 adjacent
section valve manifolds
8. Assemble the 2 adjacent section valve manifolds
and gasket with a clamp and tighten by hand
(Figure 128B).
85
(Figure 128A).
Figure 128
6. Socket (outlet fitting)
7. Retainer
8. Flange (manifold—section
valve)
9. Gasket
10. Flange clamp
(Figure 128A).
128A).
128B).
(Figure 128B).
g033609
(Figure