Filling The Freshwater Tank; Filling The Spray Tank - Toro Multi Pro WM Operator's Manual

CAUTION
Chemicals are hazardous and can cause
personal injury.
• Read the directions on the chemical labels
before handling the chemicals, and follow
all manufacturer recommendations and
precautions.
• Keep chemicals away from your skin.
Should contact occur, wash the affected
area thoroughly with soap and clean water.
• Wear goggles and any other protective
equipment recommended by the chemical
manufacturer.
The Multi Pro WM has been specifically designed to
have high durability in order to give it the long sprayer
life you need. Different materials have been chosen
for specific reasons at different locations on your
sprayer to meet this goal. Unfortunately, there is no
single material which is perfect for all foreseeable
applications.
Some chemicals are more aggressive than others
and each chemical interacts differently with various
materials. Some consistencies (e.g., wettable
powders, charcoal) are more abrasive and lead to
higher wear rates. If a chemical is available in a
formulation that would provide increased life to the
sprayer, use this alternative formulation.
As always, remember to clean your machine and
spray system thoroughly after all applications. This
ensures that your sprayer has a long and trouble-free
life.

Filling the Freshwater Tank

Always fill the freshwater tank with clean water before
handling or mixing any chemicals.
The freshwater tank is located on the ROPS, behind
the passenger seat (Figure
fresh water for you to wash chemicals off of your skin,
eyes, or other surfaces in case of accidental exposure.
•
To fill the tank, unscrew the cap on the top of the
tank and fill the tank with fresh water. Replace
the cap.
•
To open the freshwater tank spigot, turn the lever
on the spigot.
82). It supplies a source of
1. Filler cap
2. Freshwater tank

Filling the Spray Tank

Install the Chemical Pre-Mix Kit for optimal mixing and
exterior tank cleanliness.
Important:
Ensure that the chemicals you use
are compatible for use with Viton
manufacturer's label; it should indicate if it is
not compatible). Using a chemical that is not
compatible with Viton
the sprayer, causing leaks.
Important:
After filling the tank for the first time,
check the tank straps for any play. Tighten them
as necessary.
1. Park the machine on a level surface, move the
range selector to the neutral position, engage
the parking brake, shut off the engine, and
remove the key.
2. Determine the amount of water needed to mix
the amount of chemical you need as prescribed
by the chemical manufacturer.
3. Open the tank cover on the spray tank.
Note:
The tank lid is located in the center of the
top of the tank. To open it, turn the front half of
the cover counterclockwise and swing it open.
You can remove the strainer inside for cleaning.
56
Figure 82
3. Spigot
TM (see the
TM degrades the O-rings in
g210327