Toro Multi Pro WM Operator's Manual page 88

Installing the Jackstands
Lifting equipment capacity: 408 kg (900 lb)
1. Align the front jackstand with the jackstand
receiver at the front of the tank
Figure 130
1. Clevis pin (1/2 x 3 inch)
2. Jackstand receiver
3. Lock knob
2. Insert the jackstand into the receiver until the
middle hole in the horizontal jackstand tube is
aligned with the hole in the top of the receiver
(Figure 130).
3. Insert the clevis pin (1/2 x 3 inches) into the
holes in the jackstand and receiver and secure
the clevis pin with a hairpin (5/32 x 2-5/8 inches).
4. Thread a lock knob into the receiver and tighten
the knob by hand
5. Align the rear jackstand with the rear jackstand
receiver (Figure 131).
(Figure 130).
4. Hairpin (5/32 x 2-5/8
inches)
5. Front jackstand
(Figure 130).
g028422
1. Hairpin (5/32 x 2-5/8
inches)
2. Clevis pin (1/2 x 4-1/2
inches)
6. Align the hole in the top of the jackstand with the
hole in the frame of the tank skid
7. Secure the jackstand to the receiver and the
frame with 2 clevis pins (1/2 x 4-1/2 inches) and
2 hairpins (5/32 x 2-5/8 inches) as shown in
Figure 131.
8. Repeat steps
jackstands at the other side of the tank skid.
88
Figure 131
3. Jackstand receiver
4. Rear jackstand
(Figure
1 through 7 for the front and rear
g028423
131)