Lowering The Tank Skid; Bolt; Locknut (1/2 Inch) - Toro Multi Pro WM Operator's Manual

10. Squeeze the sides of the battery cover, align the
tabs of the cover with the slots in the battery
base, and release the battery cover
Figure 33
1. Slot (battery base)
13

Lowering the Tank Skid

Parts needed for this procedure:
2 Bolt (1/2 x 1-1/2 inch
2

Locknut (1/2 inch)

Procedure
1. Start the machine and raise the tank skid slightly
with the lift cylinders.
2. Remove the bed support from the lift cylinder
and stow the support in the storage brackets
at the back of the ROPS panel
Figure 35).
Figure 34
(Figure 33).
g033557
2. Tab (battery cover)
(Figure 34 and
g033569
1. Bed support
3. Use lift cylinders to slowly lower the tank to the
frame.
Note:
Have another person observe the tank
skid as it lowers. Look for hoses and wiring that
might become pinched or bent.
4. Check the alignment of the tank skid to the
frame of the machine.
5. Remove the access panels at both sides of the
skid frame (Figure
1. Access panel door
2. Bolt (1/2 x 1-1/2 inch
6. Check the hoses or wiring that you can see
through the opening in the skid frame for signs
of pinching or bending.
Important:
If any hoses or wiring on the
tank skid assembly are pinched or bent,
raise the assembly up, adjust its positioning,
and tie the items back.
7. Align the front mounting brackets with the
hold-down brackets installed in
Hold-Down Brackets for the Tank Skid (page
8. Secure the hold down bracket of the tank skid
assembly to the bed bracket on the frame at
30
Figure 35
36).
Figure 36
3. Locknut (1/2 inch)
3 Installing the
g002397
g022355
18).