Toro Multi Pro WM Operator's Manual page 28

Figure 27
1. T-bolt
2. Nut
2. Remove the cover (narrow) from the positive
battery cable (Figure
Note:
You no longer need the narrow battery
cover.
3. Positive battery cable
(machine)
4. Negative battery cable
(machine)
28).
g033559
1. Cover–narrow (battery
terminal—red)
2. Positive battery cable
(machine)
3. Install the wide battery cover over the positive
battery cable as shown in
Note:
Slide the cover far enough over the
cables to allow access to the post clamp.
4. Align the ring terminal of the fusible link (sprayer
wire harness) though the wide battery cover as
shown in
28
Figure 28
3. Cover–wide (battery
terminal—red)
Figure
Figure 29.
g033568
28.