Toro Multi Pro WM Operator's Manual page 29

Figure 29
1. Cover–wide (battery
terminal—red)
5. Loosely assemble a terminal bolt and a clamp
nut to the positive and negative battery-cable
clamps (Figure 30).
Figure 30
1. Terminal bolt
2. Clamp nut
6. Secure the ring terminal of the fusible link
(sprayer wire harness) to the post of the terminal
bolt that you assembled to the positive battery
cable with a clamp nut
g033560
2. Terminal (fusible-link
harness—sprayer
harness)
g033558
3. Positive battery-cable
clamp
4. Negative battery-cable
clamp
(Figure 31).
1. Ring terminal (fusible-link
harness—sprayer
harness)
2. Positive battery cable
(machine)
3. Negative battery cable
(machine)
7. Secure the ring terminal of the negative wire
(black—sprayer wire harness) to the post of the
terminal bolt that you assembled to the negative
battery cable with a clamp nut
8. Assemble the positive battery cable onto the
positive battery post and tighten the clamp nut
by hand (Figure
1. Cover–new (battery
terminal—red)
2. Positive battery post
9. Assemble the negative battery cable onto the
negative battery post and tighten the clamp nut
by hand.
29
Figure 31
4. Clamp nut
5. Terminal bolt
6. Ring terminal (negative
battery wire—sprayer wire
harness)
(Figure 31).
32).
Figure 32
3. Negative battery post
g033561
g033567