Storage - Toro Multi Pro WM Operator's Manual

9. For the left or right boom section valves,
assemble the valves to the valve mount with
the flanged-head bolt and flanged locknut that
you removed in step
Manifold Valve (page 80)
and bolts to 10 to 12 N∙m (90 to 110 in-lb).
10. If you loosened the mounting hardware for the
bypass fitting, tighten the nut and bolt to 10 to 12
N∙m (90 to 110 in-lb).
Installing the Valve Actuator
1. Align the actuator to the manifold valve and
(Figure 109).
2. Secure the actuator and valve with the retainer
that you removed in step
Valve Actuator (page
3. Connect the 3-pin connector of the valve-actuator
harness to the 3-socket connector of the wire
harness of the sprayer.
3 of Removing the Section
and torque the nuts
3 of Removing the
76).

Storage

1. Park the machine on a level surface, engage the
parking brake, shut off the pump, shut off the
engine, and remove the key.
Note:
For HD- and HDX-Series Workman
models with a manual transmission, disengage
the PTO.
2. Clean dirt and grime from the entire machine,
including the outside of the cylinder-head fins of
the engine and blower housing.
Important:
with mild detergent and water. Do not use
high-pressure water to wash the machine.
Pressure washing may damage the electrical
system or wash away necessary grease at
friction points. Avoid excessive use of water,
especially near the control panel, lights,
engine, and the battery.
3. Condition the sprayer system as follows:
A. Drain the freshwater tank.
B. Drain the spray system as completely as
possible.
C. Prepare rust inhibiting, non-alcohol based,
RV antifreeze solution per the solution
manufacturer's instructions.
D. Add the RV antifreeze solution to the
freshwater tank and the sprayer tank.
E. Run the sprayer pump for a few minutes
to circulate the RV antifreeze throughout
the sprayer system and any installed spray
accessories; refer to
43).
F. Drain the freshwater tank and spray system
as completely as possible.
4. Use the boom-lift switches to raise the booms.
Raise the booms until have moved completely
into boom transport cradle forming the "X"
transport position and the boom cylinders are
fully retracted.
Note:
Make sure that the boom cylinders are
fully retracted to prevent actuator rod damage.
5. Perform the following maintenance steps for
short-term or long-term storage:
•
Short-term storage (less than 30 days),
clean the sprayer system; refer to
the Sprayer (page
•
Long-term storage (longer then 30 days),
perform the following:
A. Clean the sprayer valves; refer to
Cleaning the Sprayer Valves (page
86
You can wash the machine
Sprayer Pump (page
59).
Cleaning
76).