Operating The Booms - Toro Multi Pro WM Operator's Manual

To seal the tank, close the cover and rotate the
front half clockwise.
4. Add 3/4 of the required water to the spray tank
using the anti-siphon fill receptacle.
Important:
Always use fresh clean water in
the spray tank. Do not pour concentrate into
an empty tank.
5. Start the engine, engage the PTO, and set the
hand throttle if equipped.
6. Turn the agitation switch O
7. Add the proper amount of chemical concentrate
to the tank, as directed by the chemical
manufacturer.
Important:
If you are using a wettable
powder, mix the powder with a small amount
of water to form a slurry before adding it to
the tank
8. Add the remaining water to the tank.
Note:
For better agitation, decrease the
application rate setting.

Operating the Booms

The boom-lift switches on the sprayer control panel
allow you to move the booms between the transport
position and the spray position without leaving the
operator's seat. Change boom positions while the
machine is stationary.
Setting the Hydraulic Lift Lock
Engage the hydraulic lift lever and lock it to provide
hydraulic power for control of the boom lift.
1. Push forward the hydraulic-lift lever
or Figure 84).
Manual Transmission Workman Vehicles
1. Push forward
2. Move left
position.
N
(Figure 83
Figure 83
3. Hydraulic-lift lock
4. Hydraulic-lift lever
Automatic Transmission Workman Vehicles
1. Push forward
2. Move left
2. Move the hydraulic-lift lock left to engage the
lock (Figure 83
Changing the Boom Position
Perform the following steps to move the booms to the
spray position:
1. Park the machine on a level surface.
2. Use the boom-lift switches to lower the booms.
Note:
Wait until the booms reach the full,
extended spray position.
Complete the sprayer job, then perform the following
steps to retract the booms into the transport position:
1. Park the machine on a level surface.
2. Use the boom-lift switches to raise the booms,
until they have moved completely into boom
transport cradle forming the "X" transport
position and the boom cylinders are fully
retracted.
Important:
boom actuator cylinder, make sure that
the actuators are fully retracted before
transporting the machine.
Using the Boom Transport Cradle
The sprayer is equipped with a boom transport cradle
that has a unique safety feature. In the event of
accidental boom contact with a low overhead object
while in the transport position, you can push the
boom(s) out of the transport cradles. If this occurs,
g255717
the booms come to rest in a near horizontal position
to the rear of the vehicle. While this movement will not
damage the booms, they should be immediately put
back into the transport cradle.
Important:
The booms can be damaged by
transporting them in any position other than the
57
Figure 84
3. Hydraulic-lift lock
4. Hydraulic-lift lever
or Figure 84).
To prevent damage to the
g255830