Toro Multi Pro WM Operator's Manual page 79

Removing the Master Boom
Manifold Valve
1. Remove flange clamps and gaskets that secure
the manifold for the master-boom valve
114) to the master-boom bypass valve, agitation
valve, and 90° flanged elbow (at the end of the
hose for the flow meter).
Note:
Retain the flange clamps and gaskets
for installation in
Manifold Valve (page
Figure 114
1. Flange (agitation-valve)
2. Flange
(bypass—master-boom
valve)
3. Manifold (master-boom
valve)
2. Remove the retainer that secure the 90°
outlet fitting to the manifold coupling for the
master-boom valve
Installing the Master Boom
84).
4. Flange clamp
5. Gasket
6. 3-pin connector (valve
actuator—master-boom
valve)
(Figure 115).
(Figure
1. Manifold (master-boom
valve)
2. Valve mount
3. Flange locknut (1/4 inch)
3. Remove the flange-head bolt (1/4 x 3/4 inch)
and flange locknut (1/4 inch) that secure the
master-boom valve to the valve mount and
remove the valve manifold from the machine
(Figure
Note:
g033590
locknut, and retainer for installation in
the Master Boom Manifold Valve (page
79
Figure 115
4. Flange-head bolt (1/4 x
3/4 inch)
5. Retainer
6. Socket (90° outlet fitting)
115).
Retain the flange-head bolt, flange
g033591
Installing
84).