Toro Multi Pro WM Operator's Manual page 52

Setting the Protect Settings
Important:
Use this function to lock and unlock
the application rate.
Note:
You must know the 4-digit PIN number to
change settings for functions in the protected menus.
1. From the Main Menu, press the center selection
button to navigate to the Settings menu.
2. Press the center selection button to highlight the
Protect Settings entry.
Note:
If there is no X in the box to the right
of Protect Settings entry, the sub-menus for L
Boom, C Boom, R Boom, and Reset Defaults
are not locked with the PIN
Figure 73
3. Press the right selection button.
Note:
The PIN entry screen appears
4. Enter the PIN; refer to step
into the InfoCenter (page
5. Once the right-most value is set, press the right
selection button.
Note:
The Check Mark icon appears above the
center selection button.
6. Press the center selection button.
Note:
The sub-menus for L Boom, C Boom, R
Boom, and Reset Defaults appears.
7. Press the center selection button to highlight the
Protect Settings entry
8. Press the right selection button.
Note:
An X appears in the box to the to the
right of Protect Settings entry
(Figure 74).
g028524
4 in Entering the PIN
51).
(Figure 74).
9. Wait until the InfoCenter displays the "value
saved message" and the red indicator light
illuminates.
Note:
The sub-menus below the Protected
Menus entry are locked with the PIN.
Note:
To access the sub-menus, highlight the
Protect Settings entry, press the right selection
button, enter the PIN, and when the Check Mark
icon appears—press the center selection button.
Resetting the Boom Section Sizes to Default
1. Press the center selection button to navigate to
the Reset Default entry
2. Press the right selection button to select Reset
Default.
3. In the Default Settings screen, press the left
selection button for N
button for Y
ES
Note:
Selecting Y
sizes to the factory setting.
52
Figure 74
(Figure 75).
Figure 75
or the right selection
O
(Figure 75).
restores the boom-section
ES
g028523
g028526