Setup - Toro Multi Pro WM Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
Description
No parts required
Rear PTO Kit, Heavy-Duty Workman
Vehicle (HD-Series Models with a
Manual Transmission)
Multi Pro WM Turf Sprayer Finishing
Kit, Manual Workman Utility Vehicle
(HD-Series Models with a Manual
Transmission)
Multi Pro WM Turf Sprayer Finishing
Kit, Manual Workman Utility Vehicle
(HD-Series Models with a Manual
Transmission)
Multi Pro WM Turf Sprayer Finishing
Kit, Automatic Workman Utility Vehicle
(HDX-Auto Model)
Hold-down brackets
Tank and skid assembly
Clevis pins
Tapered clevis pin
Hairpins
Lynch pins
Bolt (1/2 x 1-1/2 inches)
Nuts (1/2 inch)
No parts required
No parts required
No parts required
No parts required
Console mounting bracket
Flange locknut (5/16 inch)
Flange-head bolt (5/16 inch)
Plastic bushing
Control console
Spring-clip pin
Hand knob
J-clips
Bolt (1/4 x 3/4 inch)
Flange nut (1/4 inch)
Fuse decal (127–3966)
Qty.
–
Remove the existing bed.
1
1
Prepare to install the center boom
section.
1
1
Install the attachment hold-down
2
brackets.
1
2
2
2 Install the tank skid.
4
2
2
–
Assemble the drain valve.
–
Disconnect the battery.
–
Connect the speed sensor harness.
–
Couple the sprayer pump.
1
3
3
Install the control console to the
2
machine.
1
1
1
3
Install the control console onto the
1
machine.
1
Install the control console and the
1
electrical harness.
14
Use