Assembling The Sprayer Tank Fill Fitting; Checking The Section-Hinge Springs - Toro Multi Pro 5800-D Operator's Manual

1
Assembling the Sprayer
Tank Fill Fitting
Parts needed for this procedure:
1 Quick-disconnect fitting
Procedure
Note:
To complete this procedure, you will need to
supply a hose with 1 inch male national pipe thread
(NPT) fitting and PTFE thread sealant.
1. At the forward, right side of the tank cover,
remove the 2 hairpins that secure the latches for
the quick-disconnect coupling for the anti-siphon
fill receptacle (Figure
1. Quick-disconnect fitting
2. Hairpins
2. Rotate the latches open to unlock
the quick-disconnect fitting from the
quick-disconnect coupling
3. Remove the quick-disconnect fitting from the
quick-disconnect coupling
4. Close the latches and install the hairpins into the
flanges of the quick-disconnect coupling
3).
5. Apply PTFE thread sealant
threads of the fill hose fitting (1 inch—national
pipe thread).
3).
Figure 3
3. Latches (quick-disconnect
coupling)
(Figure 3).
(Figure 3).
(Figure 4) to the
1. PTFE thread sealant
2. Fill hose fitting (1
inch—national pipe
thread)
6. Thread the quick-disconnect coupling onto the
fill hose and tighten it by hand
2
Checking the Section-Hinge
Springs
No Parts Required
Procedure
Important:
the section-hinge springs under the incorrect
compression could damage the boom assembly.
Measure the springs and use the jam nut to
compress the springs to 4 cm (1-1/2 inches) if
necessary.
The sprayer is shipped with the section extensions
swung forward to facilitate shipping the machine.
g242085
The springs are not fully tightened at the time of
manufacture to allow the sections to be in this position
for transit. Before operating the machine, adjust the
springs to the correct compression.
1. If necessary, remove the packing components
that secure the right and left extension sections
during shipping.
2. Support the sections while they are extended to
the spray position.
3. At the section hinge, measure the compression
of the upper and lower springs while the sections
are in their extended position
(Figure
A. Compress both springs until they measure
4 cm (1-1/2 inches).
B. Use the jam nut to compress any spring that
measures more than 4 cm (1-1/2 inches).
13
Figure 4
3. Quick-disconnect fitting
Operating the spray system with
(Figure
g191615
(Figure 4).
5).