Operation; Think Safety First; Adjusting The Booms To Level - Toro Multi Pro WM 41240 Operator's Manual

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
Note: If you ever need to transport the vehicle on a trailer
with the sprayer attached, make sure the booms are tied down
and secure.

Think Safety First

Please carefully read all of the safety instructions and decals
in the safety section. Knowing this information could help
you or bystanders avoid injury.
Filling the Fresh Water Tank
Always fill the fresh water tank with clean water before
handling or mixing any chemicals.
The sprayer is equipped with a fresh water tank. It supplies a
source of fresh water for you to wash chemicals off your skin,
eyes, or other surfaces in the case of accidental exposure.
To open the fresh water tank spigot, turn the spigot lever
towards the front of the sprayer.

Adjusting the Booms to Level

The following procedure can be used to adjust the actuators
on the center boom to keep the left and right booms at level.
1. Extend the booms to the spray position.
2. Remove the cotter pin from the pivot pin (Figure 34).
1
Figure 34
1. Actuator
2. Actuator rod
3. Boom-pivot pin housing
4
2
5
3
G013780
4. Cotter
5. Pin
3. Lift up on the boom and remove the pin (Figure 34),
and slowly lower the boom to the ground.
4. Inspect the pin for any damage, and replace it if
necessary.
5. Use a wrench on the flat sides of the actuator rod to
immobilize it, then loosen the jam nut to allow the
eyelet rod to be manipulated (Figure 35).
1. Flat on the actuator rod
2. Jam nut
3. Eyelet
4. Jam nut loosened
6. Turn the eyelet rod in the actuator rod to shorten or
lengthen the extended actuator to the desired position
(Figure 35).
Note: You must turn the eyelet rod in half or complete
revolutions so that you can assemble the rod to the
boom.
7. Once the desired position has been achieved, tighten
the jam nut to secure the actuator and eyelet rod.
8. Raise the boom to align the pivot with the actuator rod.
9. While holding the boom, insert the pin through both
boom pivot and actuator rod (Figure 34).
10. With the pin in place, release the boom and secure the
pin with the cotter previously removed.
11. Repeat the procedure for each actuator rod bearing,
if necessary.
28
1
2
3
4
5
6
7
G014220
Figure 35
5. Eyelet adjusted
6. Eyelet position for
assembly
7. Jam nut tightened to lock
new position