Changing The Pressure Filter; Inspecting The Sprayer Pump; Adjusting The Booms To Level - Toro Multi Pro WM 41240 Operator's Manual

Changing the Pressure
Filter
Service Interval: Every 400 hours
1. Move the machine to a level surface, shut off the
sprayer pump, shut off the engine, and remove
the key from the
2. Align a drain pan under the pressure filter
(Figure 82).
Figure 82
1. Filter head
2. O-ring (bowl)
3. Filter element
3. Rotate the drain plug counterclockwise and
remove it from the bowl of the pressure filter
(Figure 82).
Note:
Allow the bowl to drain completely.
4. Rotate the bowl counterclockwise and remove it
filter head (Figure
5. Remove the old pressure filter element
82).
Note:
Discard the old filter.
6. Check the O-ring for the drain plug (located
inside the bowl) and the O-ring for bowl (located
inside the filter head) for damage and wear
(Figure 82).
Note:
Replace any damaged or worn O-rings
for the plug, bowl, or both.
7. Install the new pressure filter element into the
filter head (Figure
Note:
Ensure that the filter element is firmly
seated into the filter head.
8. Install the bowl onto the filter head hand tight
(Figure 82).
switch.
STARTER
4. Bowl
5. O-ring (drain plug)
6. Drain plug
82).
82).
9. Install the plug into the bowl hand tight
82).
Inspecting the Sprayer
Pump
Service Interval: Every 400 hours/Yearly (whichever
Every 400 hours/Yearly (whichever comes
first)—Inspect the pump check valves and
replace if necessary (see an Authorized Toro
Service Distributor).
Note:
The following machine components are
considered parts subject to consumption through use
unless found defective and are not covered by the
Warranty associated with this machine.
Have an Authorized Toro Service Distributor check
following internal pump components for damage:
•
Pump diaphragm
•
Pump check valves assemblies
g028235
Replace any components if necessary.
Adjusting the Booms to
Level
The following procedure can be used to adjust the
actuators on the center boom to keep the left and
right booms at level.
1. Extend the booms to the spray position.
2. Remove the cotter pin from the pivot pin
83).
(Figure
63
comes first)—Inspect the pump
diaphragm and replace if necessary
(see an Authorized Toro Service
Distributor).
(Figure
(Figure