Changing The Nozzle Filter; Adjusting The Booms To Level - Toro Multi Pro 5800-G Operator's Manual

8. Install the bowl onto the filter head and tighten
by hand (Figure 99).
9. Install the plug into the bowl and tighten by hand
(Figure 99).

Changing the Nozzle Filter

Note:
Determine the appropriate nozzle filter mesh
size that you need for your job; refer to
Nozzle-Tip Filter (Optional) (page
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Remove the nozzle from the spray turret
100).
Figure 100
1. Spray turret
2. Nozzle filter
3. Remove the old nozzle filter
Note:
Discard the old filter.
4. Install the new nozzle filter
Note:
Ensure that the filter is fully seated.
5. Install the nozzle onto the spray turret
100).
Selecting a
46).
(Figure
g209504
3. Nozzle
(Figure 100).
(Figure 100).
(Figure
Adjusting the Booms to
Level
The following procedure can be used to adjust the
actuators on the center boom to keep the left and
right booms at level.
1. Extend the booms to the spray position.
2. Remove the cotter pin from the pivot pin
101).
1. Actuator
2. Actuator rod
3. Boom-pivot pin housing
3. Lift up on the boom and remove the pin
101), and slowly lower the boom to the ground.
4. Inspect the pin for any damage, and replace it
if necessary.
5. Use a wrench on the flat sides of the actuator
rod to immobilize it, then loosen the jam nut to
allow the eyelet rod to be adjusted
74
Figure 101
4. Cotter
5. Pin
(Figure
(Figure
g013780
(Figure
102).