Factory Setting After Switch-On - Sirona Orthophos XG 3D/Ceph Installation Manual

Sirona Dental Systems GmbH
Installation Manual ORTHOPHOS XG 3D / Ceph
B
A
T R
63 03 452 D3352
D3352.031.05.08.02 10.2015
IMPORTANT
After switch-on, the unit requires approx. 1 min. of warm-up time.
At the same time, the self-adjustment routine for the mechanics and the
electronics of the unit is performed. If a key is pressed during the self-
adjustment routine, an error message will display on the control panel.
1. Turn the main switch (A) to position I.
2. Wait for approx. 1 minute.
 The radiation indicator X-ray (C) lights up for approx. one second
as a functional check.
 After approx. 2 seconds, the green LED B in the upper part of the
control panel lights up. This LED remains lit as long as the unit is
on.
C  The start screen is displayed on the touchscreen for several
seconds.
 The program selection is then displayed on the touchscreen.
 The forehead support and temple supports are completely open.
3. Check whether the patient symbols on the touchscreen can be
selected in exactly the right position.
If problems occur during selection, adjust the touchscreen [ → 259].
4. Press the R key.
 The unit moves to its starting position.
5. Switch on the PC.
6. Start SIDEXIS.
 As long as no connection has been made to SIDEXIS, the
message
displayed in the comment line of the control panel.
11.5.1

Factory setting after switch-on

The unit has the following factory configuration on delivery:
Factory setting after switch-on: XG 3D/3D ready
● The acoustic signal for end of exposure is activated.
● The unit language is preconfigured as ordered.
● The preview image is switched on.
● The welcome screen is switched on.
● The first name, last name and date of birth lines are displayed on the
welcome screen.
If the customer requires a different configuration, this can be implemented
via service routine S017.
"Switch SIDEXIS to ready for exposure state"
11 Initial startup
11.5 Switching the unit on
is
101