S018: Service For Height Adjustment - Sirona Orthophos XG 3D/Ceph Installation Manual

11 Initial startup
11.10 Service routines for startup
SR*
S018
S018.2
S018.3
S018.4
S018.5
S018.6
S018.7
S018.8
S018.9
S018.10
152
11.10.4

S018: Service for height adjustment

SHZ** Function
S018 XG 3D / XG 3D ready
Service for height adjustment
No Setting the maximum travel height
No Undoing the maximum travel height setting
No Checking the height adjustment sensor system
No Setting the minimum travel height
No Undoing the minimum travel height setting
No Setting the nominal angle for the occlusal bite block (as required by the
customer) (occlusal bite block only)
NOTICE! This routine may only be selected for units with occlusal bite
block; otherwise, the unit will malfunction!
No Function test of the occlusal bite block (occlusal bite block only)
NOTICE! This routine may only be selected for units with occlusal bite
block; otherwise, the unit will malfunction!
No Adjustment of the AD acceptance angle values and the zero point
NOTICE! This routine may only be selected for units with occlusal bite
block; otherwise, the unit will malfunction!
No Setting the PWM values for the height adjustment creep speed
(PWM=Pulse Width Modulation)
NOTICE! This routine may only be selected for units with occlusal bite
block; otherwise, the unit will malfunction!
* SR=service routine, ** SHZ=security access
Sirona Dental Systems GmbH
Installation Manual ORTHOPHOS XG 3D / Ceph
D3352.031.05.08.02 10.2015
63 03 452 D3352