Checking The Ignition Coils; Checking The Ignition Spark Gap - Yamaha R1 Series 2015 Service Manual

unit terminal as shown.
c. Check the relay unit (diode) for continuity.
d. Check the relay unit (diode) for no continuity.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30558

CHECKING THE IGNITION COILS

The following procedure applies to all of the igni-
tion coils.
1. Check:
• Primary coil resistance
Out of specification
Primary coil resistance
0.85–1.15
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the ignition coil coupler from the
ignition coil.
b. Connect the pocket tester (
tion coil as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
Ignition coil terminal "1"
• Negative tester probe
Ignition coil terminal "2"
c. Measure the primary coil resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
2. Check:
• Secondary coil resistance
Out of specification
Secondary coil resistance
8.50–11.50 k
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the pocket tester (
nition coil as shown.
Replace.
1) to the igni-
Replace.
1 k) to the ig-
ELECTRICAL COMPONENTS
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Negative tester probe
Ignition coil terminal "1"
• Positive tester probe
Spark plug terminal "2"
2
b. Measure the secondary coil resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30556

CHECKING THE IGNITION SPARK GAP

1. Check:
• Ignition spark gap
Out of specification
system troubleshooting, starting with step 5.
Refer to "TROUBLESHOOTING" on page
8-6.
Minimum ignition spark gap
6.0 mm (0.24 in)
TIP
If the ignition spark gap is within specification,
the ignition system circuit is operating normally.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the ignition coil from the spark plug.
b. Connect the ignition checker "1" as shown.
Ignition checker
90890-06754
Oppama pet–4000 spark checker
YM-34487
8-186
1
Perform the ignition