Yamaha R1 Series 2015 Service Manual page 139

1. Steering damper solenoid coupler (OHLINS:
OPTION)
2. SCU lead (sub-wire harness)
3. Intake air temperature sensor
4. Sub-wire harness (SCU, steering damper
solenoid, sub-wire harness)
5. Auxiliary light lead
6. Sub-wire harness (front fork stepping motor)
7. Plastic locking tie
8. Front turn signal light lead (left)
9. Clamp
10.Wire harness
11.Intake solenoid vacuum hose
12.Front turn signal light lead (right)
13.SCU (Suspension Control Unit)
14.Steering damper solenoid lead
A. The steering damper solenoid coupler
(OHLINS: OPTION) may be positioned in any
place.
B. To front left turn signal light
C. Route the sub-wire harness (SCU, steering
damper solenoid, sub-wire harness) to the
left side of the fuse box 1, and then connect
to the wire harness.
D. Fasten the sub-wire harness and intake sole-
noid vacuum hose with the plastic locking tie.
Make sure that the end of the plastic locking
tie does not protrude above the intake sole-
noid vacuum hose.
E. Connect the coupler of the sub-wire harness
(front fork stepping motor) to the coupler of
the sub-wire harness (SCU, steering damper
solenoid, sub-wire harness).
F. Fasten the intake solenoid vacuum hose,
front left turn signal light lead, and auxiliary
light lead at the outside of the fuse box 1 with
the clamp.
G. Fasten the intake solenoid vacuum hose onto
the wire harness with the plastic locking tie.
Face the buckle of the plastic locking tie out-
ward. (2 locations)
H. Place the sub-wire harness to the outside of
the intake solenoid vacuum hose, and then
fasten it with the plastic locking tie.
I. Install the SCU coupler and coupler cover
securely to the SCU. Make sure that the
edges of the coupler cover are not rolled up.
J. To front right turn signal light
K. Connect the front right turn signal light cou-
pler, and then fasten the front right turn signal
light leads with the clamp. The leads may be
positioned in any order within the clamp.
L. To intake solenoid
M. To front fork
2-64
CABLE ROUTING