Yamaha R1 Series 2015 Service Manual page 688

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
61 Malfunction history code dis-
play
• No history
• History exists
62 Malfunction history code era-
sure
• No history
• History exists
63 Malfunction code reinstate-
ment (for fault code No. 24,
40, 42, 68, 69 only)
• No malfunction code
• Malfunction code exists
67 ISC (Idle Speed Control)
learning condition display
ISC (Idle Speed Control)
learning data erasure
70 Control number
86 Shift switch
• Shift pedal up position
• Other position than the shift
pedal up position
Item
00
Fault codes 8–99
• (If more than one code
number is detected, the
display alternates every
two seconds to show all the
detected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
00
• Displays the total number
of malfunctions, including
the current malfunction,
that have occurred since
the history was last erased.
(For example, if there have
been three malfunctions,
"03" is displayed.)
00
Fault code 24, 40, 42, 68, 69
• (If more than one code
number is detected, the
display alternates every
two seconds to show all the
detected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
00
ISC (Idle Speed Control)
learning data has been
erased.
01
It is not necessary to erase
the ISC (Idle Speed Control)
learning data.
02
It is necessary to erase the
ISC (Idle Speed Control)
learning data.
0–254 [-]
ON
OFF
Meter display
9-9
(ECU)
Procedure
—
—
To erase the history, set the
start/engine stop switch from
" " to " ".
—
To reinstate, set the
start/engine stop switch from
" " to " ".
To erase the ISC (Idle Speed
Control) learning data, set
the start/engine stop switch
from " " to " " 3 times in 5
seconds.
—
Check the switch condition
by operating the shift pedal.