Yamaha R1 Series 2015 Service Manual page 161

1. Air filter case
2. Air cut-off valve
3. Air induction system hose (air filter case to air
cut-off valve)
4. Cylinder head cover
5. Air induction system hose (air cut-off valve to
reed valve cover)
6. Cylinder identification sensor
7. Cylinder identification sensor lead
A. Point the end of the clamp to the right. Install
the air induction system hose with its white
paint mark facing outward. Make sure that
the clamp is not installed on the flange of the
hose fitting of the air filter case.
When installing the air induction system
hose, may apply silicone fluid or water to the
air induction system hose.
B. Point the end of the clamp to the left.
C. Point the end of the clamp upward.
D. Insert the air induction system hose until it
contacts the reed valve cover. Make sure that
the clamp is not installed on the flange of the
hose fitting of the reed valve cover.
E. Point the end of the clamp to the right.
2-86
CABLE ROUTING