Installing The Radiator - Yamaha R1 Series 2015 Service Manual

EAS30440

INSTALLING THE RADIATOR

1. Install:
• Radiator
2. Connect:
• Radiator inlet hose
• Radiator outlet hose
3. Install:
• Hose clamp (Clic-R) "1"
TIP
• Install the hose clamp using the hose clamp pli-
ers "2".
• When installing the hose clamp, make sure
that the thin tip "a" of the hose clamp pliers is
directed as shown in the illustration.
• For more information about installing the hose,
refer to "CABLE ROUTING" on page 2-51.
1 2
A. Hose clamp pliers
4. Fill:
• Cooling system
(with the specified amount of the recom-
mended coolant)
Refer to "CHANGING THE COOLANT" on
page 3-33.
5. Check:
• Cooling system
Leaks Repair or replace any faulty part.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Attach the radiator cap tester "1" and radiator
cap tester adapter "2" to the radiator.
New
a
6-3
Radiator cap tester
90890-01325
Mityvac cooling system tester kit
YU-24460-A
Radiator cap tester adapter
90890-01352
Pressure tester adapter
YU-33984
b. Apply 137.3 kPa (1.37 kgf/cm², 19.9 psi) of
pressure.
c. Measure the indicated pressure with the
gauge.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6. Measure:
• Radiator cap opening pressure
Below the specified pressure
radiator cap.
Refer to "CHECKING THE RADIATOR" on
page 6-2.
RADIATOR
1
2
Replace the