Error Mode - Yamaha R1 Series 2015 Service Manual

4. When the lap timer has been activated, press
the PASSING/LAP switch to start the lap tim-
er.
TIP
• Set the information display to FASTEST or AV-
ERAGE for additional lap time information.
• Accessing the MENU screen will automatically
stop the lap timer.
• Whenever the lap timer is stopped, the current
lap will not be recorded.
• The lap time record can be viewed and reset
from the MENU screen.
Oil pressure warning
This icon, along with the oil pressure and coolant
warning light, comes on when the engine oil
pressure is low. When the key is first turned to
ON, engine oil pressure has yet to build, so this
icon will come on and stay on until the engine
has been started.
ECA22790
NOTICE
If the warning light comes on when the en-
gine is running, stop the engine immediately
and check oil level. If the oil level is below the
minimum level, add sufficient oil of the rec-
ommended type to raise it up to the correct
level. If the oil pressure warning light re-
mains on even if the oil level is correct, im-
mediately turn the engine off and check the
vehicle.
Coolant temperature warning
This icon comes on if the coolant temperature
reaches 117 C (242 F) or higher. Stop the ve-
hicle and turn off the engine. Allow the engine to
cool.
ECA10022
NOTICE
Do not continue to operate the engine if it is
overheating.

Error mode

1000 r/min
×
1. SCU trouble warning "
2. SCU error code
3. Engine trouble warning "
4. ECU error code
5. Error mode warning "Err"
When an error is detected, the top portion of the
main screen will switch to error mode. The fol-
lowing error-related warning icons and error
codes will then be viewable.
• SCU trouble warning icon
• SCU error code
• Engine trouble warning icon
• ECU error code
SCU trouble warning (YZF-R1M)
The SCU trouble warning icon appears if a prob-
lem is detected by the suspension control unit
and an SCU error code will be shown. Note the
number and then, check the electronically ad-
justable suspension system. (Refer to "ELEC-
TRONICALLY ADJUSTABLE SUSPENSION
SYSTEM (for YZF-R1M)" on page 8-153.)
Engine trouble warning
The engine trouble warning icon appears if a
problem is detected by the engine control unit
and an ECU error code will be shown. Note the
number and then, check the fuel injection sys-
tem. (Refer to "FUEL INJECTION SYSTEM" on
page 8-45.)
TIP
If the display indicates error code 52, or if you
have trouble starting the engine with a standard
key, this could be caused by transponder inter-
ference. If this occurs, try the following.
1. Make sure there are no other immobilizer
keys, or other devices which transmit electri-
cal signals, close to the main switch.
2. Use the code re-registering key to start the
engine.
3. If the engine starts, turn it off, and try starting
the engine with the standard keys.
1-35
FEATURES
1 2 3 4
90 90
"
"
5
E r r