Installing The Crankcase Breather Cover; Installing The Oil Pressure Switch - Yamaha R1 Series 2015 Service Manual

7
5
4
10
8. Tighten:
• Crankcase bolts "11"–"40"
Crankcase bolts "11"–"20"
24 Nm (2.4 m·kgf, 17 ft·lbf)
Crankcase bolts "21"–"40"
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Tighten the bolts "11"–"18" in the tightening se-
quence cast on the crankcase.
21
31
15 32
17
18
16
30
29
28 26
27
38
40
39 37
3 9
1
2 6 8
34
33
13
11
23
14
35
12
22
24
25
19
20
36
EAS31718
INSTALLING THE CRANKCASE BREATHER
COVER
1. Install:
• Crankcase breather cover
• Crankcase breather cover bolt
2. Tighten:
• Crankcase breather cover bolt
Crankcase breather cover bolt
*
Following the tightening order, loosen the bolt
one by one and then retighten it to the specific
torque and the specific angle.
TIP
Tighten the crankcase breather cover bolts in
the tightening sequence as shown.
10
8
EAS31071

INSTALLING THE OIL PRESSURE SWITCH

1. Install:
• Oil pressure switch "1"
• Oil pressure switch lead "2"
Oil pressure switch
Oil pressure switch lead bolt
TIP
• Apply Three Bond No. 1215B® to the threads
"a" of the oil pressure switch. However, do not
apply Three Bond No. 1215B® to the portion
"b" of the oil pressure switch.
• Install the oil pressure switch lead so that it is
routed within the range shown in the illustra-
tion.
30
5-69
CRANKCASE
1st: 6 Nm (0.6 m·kgf, 4.3 ft·lbf)
*2nd: 3.0 Nm (0.30 m·kgf, 2.2
ft·lbf)
Specified angle 90
2
1
7
6
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
1.8 Nm (0.18 m·kgf, 1.3 ft·lbf)
New
3
4
5