Yamaha R1 Series 2015 Service Manual page 332

a 1
2
A. Left side
B. Right side
3. Install:
• Swingarm
• Pivot shaft "1"
Pivot shaft
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
Tighten the pivot shaft with the damper rod hold-
er (22 mm) "2".
Damper rod holder (22 mm)
90890-01365
2
4. Install:
• Pivot shaft ring nut "1"
Pivot shaft ring nut
65 Nm (6.5 m·kgf, 47 ft·lbf)
1 a
1 2
b
1
TIP
Tighten the pivot shaft ring nut with the ring nut
wrench "2".
Ring nut wrench
90890-01507
Ring nut wrench
YM-01507
5. Install:
• Pivot shaft nut "1"
Pivot shaft nut
105 Nm (10.5 m·kgf, 76 ft·lbf)
6. Install:
• Drive chain
Refer to "INSTALLING THE DRIVE CHAIN"
on page 4-119.
• Rear shock absorber assembly
Refer to "REAR SHOCK ABSORBER AS-
SEMBLY" on page 4-104 .
• Rear wheel
Refer to "REAR WHEEL" on page 4-34.
7. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-19.
Drive chain slack
25.0–35.0 mm (0.98–1.38 in)
4-115
SWINGARM
2
1
1