Yamaha R1 Series 2015 Service Manual page 258

ECA19150
NOTICE
Replace the brake disc bolts with new ones.
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-59.
3. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
4. Install:
• Collars
• Brake caliper bracket
• Rear wheel
• Adjusting blocks
• Rear wheel axle
• Washer
• Rear wheel axle nut
TIP
• Do not install the brake caliper.
• Align the slot "a" in the swingarm with the pro-
jection "b" of the brake caliper bracket.
• Install the adjusting block so that projection "c"
faces to the front of the vehicle.
a
LT
b
4-41
c
5. Install:
• Rear brake caliper
• Rear brake caliper bolts
6. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-19.
Drive chain slack
25.0–35.0 mm (0.98–1.38 in)
7. Tighten:
• Rear wheel axle nut
• Rear brake caliper bolts
Rear wheel axle nut
190 Nm (19 m·kgf, 137 ft·lbf)
Rear brake caliper bolt (front)
27 Nm (2.7 m·kgf, 20 ft·lbf)
Rear brake caliper bolt (rear)
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
LOCTITE®
EWA13500
WARNING
Make sure the brake hose is routed properly.
TIP
When tightening the wheel axle nut, there
should be no clearance "a" between the adjust-
ing block "1" and adjusting bolt "2".
a
2
A. Left side
B. Right side
REAR WHEEL
1
a
2