Adjusting The Accelerator Position Sensor - Yamaha R1 Series 2015 Service Manual

h. Diagnostic code number "01" is selected.
i. Adjust the position of the throttle position sen-
sor angle so that 11–21 can appear in the
meter right display.
j. After adjusting the throttle position sensor an-
gle, tighten the throttle position sensor bolt
"6".
Throttle position sensor bolt
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30486
ADJUSTING THE ACCELERATOR POSITION
SENSOR
EWA16700
WARNING
• Handle the accelerator position sensor with
special care.
• Never subject the accelerator position sen-
sor to strong shocks. If the accelerator po-
sition sensor is dropped, replace it.
1. Check:
• Accelerator position sensor
Refer to "CHECKING THE ACCELERATOR
POSITION SENSOR" on page 8-191.
2. Adjust:
• Accelerator position sensor angle
TIP
Before adjusting the accelerator position sensor,
the throttle bodies must be removed.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Temporary tighten the accelerator position
sensor.
b. Check that the throttle valves are fully closed.
c. Connect the accelerator position sensor to
the wire harness.
d. Connect the throttle cables to the throttle bod-
ies.
e. Turn the main switch to "OFF".
f. Simultaneously press and hold the up button
"1" and center button "2", turn the main switch
6
6
7-17
THROTTLE BODIES
to "ON", and continue to press the buttons for
8 seconds more.
TIP
"ECU" "3" appears on the display.
LCS QS LIF
1000 r/min
×
ECU
SELECT
1234.5
TRIP-2
MODE - A
ETV
g. Press the up button "1" or down button "4" to
select ECU in the display, and then simulta-
neously press the up button "1" and center
button "2" for 2 seconds or more.
TIP
"DIAG" "5" appears on the display.
LCS QS LIF
1000 r/min
×
1234.5
DIAG
1234.5
TRIP-2
A
MODE -
ETV
5
h. Simultaneously press the up button "1" and
1
2
12 : 00
A-1 GPS
km/h
N
1 2
km
km
1 1 1
TCS SCS
3
1
2
4
12 : 00
GPS
A-1
km/h
N
1 2
km
km
1 1 1
TCS SCS