Yamaha R1 Series 2015 Service Manual page 145

Table of Contents

Advertisement

1. Rear wheel sensor coupler
2. Rear brake light switch coupler
3. Hydraulic unit
4. Battery
5. Joint coupler
6. Yamaha diagnostic tool coupler
7. Tail/brake light lead
8. Rear turn signal light coupler
9. EXUP servo motor
10.Starter relay
11.Wire harness
12.Battery box
13.EXUP cable 2
14.EXUP cable 1
15.Rear brake light switch lead
16.Brake hose
17.Plastic locking tie
18.Rear wheel sensor lead
19.Rear shock absorber assembly stepping
motor lead (for YZF-R1M)
20.Negative battery lead
21.License plate light lead
22.Rear turn signal light lead
23.Positive battery lead
24.Starter relay lead
25.EXUP servo motor lead
26.Relay unit lead
27.Main fuse lead
28.Starter relay lead
29.Yamaha diagnostic tool coupler lead
30.Joint coupler lead
31.IMU lead
A. The rear turn signal light leads, license plate
light lead, and tail/brake light lead may be
routed in any order.
B. Insert the rear wheel sensor coupler into the
hole in the battery box.
C. Route the rear brake light switch lead to the
outside of the EXUP cable 2, and between
the brake hoses.
D. Fasten the rear wheel sensor lead and rear
brake light switch lead to the brake hose with
the plastic locking tie. Point the end of the
plastic locking tie downward.
E. Route the rear wheel sensor lead to the out-
side of the EXUP cable 1, and between the
brake hoses.
F. Route the rear shock absorber assembly
stepping motor lead to the inside of the brake
hose. (for YZF-R1M)
G. Route the rear shock absorber assembly
stepping motor lead to the outside of the
EXUP cable 1, and inside of the brake hose.
H. Insert the joint coupler until it contacts the
battery box as shown in the illustration.
I. Route the negative battery lead through the
inside of the rib.
J. Insert the Yamaha diagnostic tool coupler
until it contacts the battery box as shown in
the illustration.
K. The tail/brake light lead, license plate light
lead and rear turn signal light leads may be
routed in any order.
L. Route the positive battery lead over the
EXUP servo motor lead, starter relay lead,
and relay unit lead.
M. Insert the clamp into the hole in the battery
box.
N. Route the negative battery lead under the
joint coupler lead, Yamaha diagnostic tool
coupler lead, and IMU lead.
O. The joint coupler lead, Yamaha diagnostic
tool coupler lead, and IMU lead may be
routed in any order.
P. Route the starter relay lead under the wire
harness and negative battery lead.
Q. Install the clamp to the rib.
2-70
CABLE ROUTING

Advertisement

Table of Contents
loading

Table of Contents