Yamaha R1 Series 2015 Service Manual page 171

1. CCU (Communication Control Unit)
2. GPS unit lead
3. GPS unit coupler
4. Yamaha diagnostic tool coupler (wire har-
ness)
5. Yamaha diagnostic tool coupler (sub-wire
harness)
6. Sub-wire harness
7. Passenger seat cover
8. GPS unit
9. Cushion
A. Fasten the CCU and CCU bracket with the
plastic locking tie.
B. Fasten the CCU and CCU bracket with the
band.
C. Connect the CCU coupler (sub-wire harness)
to the CCU.
D. Insert the Yamaha diagnostic tool coupler
until it contacts the battery box.
E. Align the end of the corrugate tube with the
end of the clamp.
F. Fasten the sub-wire harness to the rear
frame with the clamp.
G. Route the GPS unit lead between the pas-
senger seat cover and the cushion.
H. Route the GPS unit lead as shown in the
illustration.
I. Route the GPS unit lead to the inside of the
vehicle through the hole in the passenger
seat cover.
J. Fasten the GPS unit lead with the clamp on
the passenger seat cover.
2-96
CABLE ROUTING