Yamaha R1 Series 2015 Service Manual page 163

1. Air intake duct valve
2. Air intake duct
3. Intake air temperature sensor
4. Surge tank
5. Surge tank hose
6. One-way valve
7. Intake solenoid vacuum hose (one-way valve
to intake solenoid)
8. Intake solenoid vacuum hose (intake sole-
noid to air intake duct valve)
9. Intake solenoid
10.Clamp
A. Insert the surge tank hose up to the end of
the surge tank.
B. Insert the intake solenoid vacuum hoses up
the end of the intake solenoid.
C. Insert the intake solenoid vacuum hose up to
the end of the R section of the air intake duct
valve pipe.
D. Insert the surge tank hose up to the end of
the one-way valve.
E. Install the clamp at a position within the 13
mm (0.51 in) range from the end of the one-
way valve.
F. Install the surge tank hose with its white paint
mark facing upward.
G. Install the intake solenoid vacuum hose up to
the end of the one-way valve.
H. Install the clamp up to the end of the rib of the
air intake duct.
I. Cut off the band of the clamp to 5 mm (0.2 in)
or less.
2-88
CABLE ROUTING