Yamaha R1 Series 2015 Service Manual page 101

TIP
Lower ring nut
1. Tighten the ring nut to 52 Nm (5.2 m·kgf, 38 ft·lbf) with a torque wrench, then loosen the lower ring
nut completely.
2. Tighten the lower ring nut to 14 Nm (1.4 m·kgf, 10 ft·lbf).
TIP
Front wheel axle pinch bolt
1. Tighten the pinch bolt "2", pinch bolt "1", and pinch bolt "2" to 21 Nm (2.1 m·kgf, 15 ft·lbf) in this order.
2. Check that the right end of the front axle is flush with the front fork. If necessary, manually push the
front axle or lightly tap it with a soft hammer until its end is flush with the front fork. However, if the
surface of the front axle end is not parallel to the surface of the front fork, align a point on the outer
edge of the axle with the fork, making sure that the axle does not protrude past the fork.
3. Tighten the pinch bolt "4", pinch bolt "3", and pinch bolt "4" to 21 Nm (2.1 m·kgf, 15 ft·lbf) in this order.
TIP
Lower bracket pinch bolt
Tighten each bolt to 23 Nm (2.3 m·kgf, 17 ft·lbf) in the order pinch bolt "1"
"1" pinch bolt "2".
4 3
2-26
TIGHTENING TORQUES
2 1
pinch bolt "2"
1
2
pinch bolt