Adjusting The Accelerator Position Sensor - Yamaha FZ09E Service Manual

3
EAS1RC1111
Throttle position sensor screw
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
ADJUSTING THE ACCELERATOR POSITION
SENSOR
EWAIRC1 7tlG
AwARNING
• Handle the accelerator position sensor with
special care.
• Never subject the accelerator position sen-
sor to strong shocks. If the accelerator po-
sition sensor is dropped, replace it.
1.
Check:
• Accelerator position sensor
Refer to "CHECKING THE ACCELERATOR
POSITION SENSOR" on page 8-1 07.
2. Adjust:
• Accelerator position sensor angle
TIP - - - - - - - - - - - - - - -
Before adjusting the accelerator position sensor,
the throttle bodies must be removed.
••••••••••••••••••••••••••••••••
a. Temporary tighten the accelerator position
sensor bolts.
b. Check that the throttle valves are fully closed.
c. Tum the main switch to "OFP'.
d. Connect the accelerator position sensor to
the wire harness.
e. Connect the throttle cables to the throttle bod-
ies.
f. Simultaneously press and hold the "SE-
LECT' button "1" and "RESET' button "2",
tum the main switch to "ON", and continue to
press the buttons for 8 seconds or more.
0
,
'
THROTILE BODIES
c:llRC
TIP - - - - - - - - - - - - - -
"dlAG" appears on the display.
g. Simultaneously press the "SELECT' button
"1" and "RESET' button
''2"
for 2 seconds or
more to set the diagnostic mode.
d i
I
1
TIP - - - - - - - - - - - - - - -
The diagnostic code number " 1" appears on the
display.
h. Diagnostic code number
"14"
is selected.
1.
Turn the throttle grip to the fully closed posi-
tion.
J. Adjust the position of the accelerator position
sensor angle so that 12-22 can appear in the
meter display.
k. After adjusting the accelerator position sen-
sor angle, tighten the accelerator position
sensor bolts "3".
Accelerator position sensor bolt
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
I. Turn the throttle grip to the fully open position.
7-13